fiat punto key replacement cost 500 replacement key; Sungilpunch`s recent blog post, Fob

If your 500 remote key fob has stopped working, it may be time to replace the battery. However, if you replace the battery and it continues to stop working the issue is probably elsewhere.

United Locksmith specializes in the creation of new keys for classic vehicles. We have the tools as well as the parts required for this service.

Dead Coin Battery

The most common reason why your Fiat 500 key fob will not unlock or lock the doors is a dead battery. The coin cell battery in the key fob is likely to drain quickly if you don't use it often enough. If your remote started to show signs of weakness such as a loss of range and then completely stopped working it is likely that the battery is dead.

Metal clips keep the battery in place in the key fob. If the clips are not tight, they can create problems with the contact, which can stop your remote from receiving power. Use a flathead screwdriver to remove the retaining clip and remove the old battery. Choose a battery that is the same size, voltage and specification as the original.

The key fob could also become corroded or damaged by water exposure. Even a short bath in soapy water can harm the electronic chip in. Keep your key fob dry.

Water Damage

If your key fob isn't functioning properly, it could be due to water damage. Key fobs have rubber seals that stop them from being damaged by light rain or splashes of water, however it is vital to keep your keys out of the ocean, pool, and the washing machine!

The key fob comes with an electronic chip that transmits a message to the immobilizer of your car. The chip is what allows the 500 to start and lock. If it gets wet, however it will cease to work.

If you're looking to determine if your key fob is functional You can clean the internal electronics with isopropyl or an electronic cleaner. It is recommended to replace the key fob if it is submerged in salt water, rather than trying to repair it yourself.

A replacement fob can cost you a bit but it's far less expensive than paying to have your Fiat 500 towed to a dealership and fixed there! You could also do it yourself by following only a few steps. Be sure to have the correct type of battery before attempting to open your key fob. You can find step-bystep directions for any key fob in your car online.

Faulty Chip

The chip in the key fob communicates with your car's immobiliser system to ensure the vehicle is only capable of starting when the correct key is used. If the chip is damaged, or damaged in any way your car will not start.

A damaged chip could occur due to a variety of reasons, but most commonly due to water damage or a dead battery. Regardless of the reason, it is best to delegate the work to a locksmith as they will be able to repair the chip for you quickly and at a cost-effective price.

If your key fob does not function after exposure to water that is clean from the tap or rain, remove the battery. Wipe down the electronic component using a paper towel. If the key fob doesn't work it's likely to be a fried chip and will need to be replaced.

Some people go to their dealer in order to get an entirely new Fiat fob. However, this can be a costly option. United Locksmith is the best option for you if would like to have your Fiat key fob repaired at a reasonable cost. We have the tools and knowledge necessary to repair your fiat 500 spare key cost key fob in a timely and professional way.

Faulty Receiver Module

fiat ducato key fob programming key fobs send a signal to the vehicle, which will unlock and close doors (and start the car for those with an automatic transmission) up to 50 feet. However, there are several things that could cause the fob how to program fiat 500 key fob stop functioning. This can be caused by a dead coin-battery water damage, worn-out buttons, a receiver issue, signal interference, or malfunctioning chips.

If the fob was stored in a place that has endured extreme trauma, such as being dropped on hard floor or getting washed in the washing machine, it may not be able to communicate with the car's Body Control Module (BCM). This is because the BCM is a secure system that will only accept a signal from a genuine original key, and not from any other.

If this is the case, you must replace your fob. A professional locksmith will take care of the entire key replacement process including programming a new key to your 500. They can even provide a clone fob that works exactly like the original (and costs only less than the cost).